Modify a Stock – Coil Count

Before you begin

Below are the steps to take to modify a Stock – Coil count. These steps begin with the following assumptions:

• You are viewing the count you wish to modify (See Find and View a Count)
• The count type of the count is Stock – Coil (See Change a Count’s Count Type)

Steps to take

Take the following steps to modify a Stock – Coil count:

1. If required, tap in the Type of Coil field and select the type reinforcing steel coil being counted.
   
   
2. If not already correct, tap in the Weight of Full Coil field then enter the weight of a full coil of the reinforcing steel being counted.
   
   
3. If required, tap in the Number of Identical Coils field then enter the number of identical reinforcing steel coils being counted.
   

The total weight of coils is calculated displayed at the end of the Details section.

After following the steps above, you may wish to:

• Create another count in the same section (See Create a Count from a Count)
• Delete the count (See Delete a Count)