Modify a Stock – HDW Coil Count

Before you begin

Below are the steps to take to modify a Stock – HDW Coil count. These steps begin with the following assumptions:

• You are viewing the count you wish to modify (See Find and View a Count)
• The count type of the count is Stock – HDW Coil (See Change a Count’s Count Type)

Steps to take

Take the following steps to modify a Stock – HDW Coil Count:

1. If required, take the following steps to change the count method:
   • Tap on the edit button (pencil symbol inside a circle, located towards the top of the screen)
     
     
   • Tap on the Count Method field and select the method by which you wish to count HDW coil
     
     
   • The count is altered to reflect the new count method. For example, if counting by percentage, you cannot also enter a weight and so the weight field is disabled.
2. If required, tap in the Type of Coil field and select the type of HDW coil being counted.
   
   
3. If not already correct, tap in the Weight of Full Coil field then enter the weight of a full coil of HDW.
   
   
4. If required (and permitted), in the Fraction of Full Coil Remaining field then enter the percentage of HDW coil remaining. For example, if three quarters (75%) of the coil remains, enter 75.
   

   Tip: If the HDW coil is full, tap on the Full button to enter 100 (100%) into the Fraction of Full Coil Remaining field.
   

   
   
5. If required (and permitted), tap in the Weight of Coil Remaining field then enter the weight of the HDW coil remaining.
   
   
6. If required, tap in the Number of Identical Coils field then enter the number of identical coils of HDW.
   

   
   

After following the steps above, you may wish to:

• Create another count in the same section (See Create a Count from a Count)
• Delete the count (See Delete a Count)