Modify a Stock – Mesh Count

Before you begin

Below are the steps to take to modify a Stock – Mesh Count. These steps begin with the following assumptions:

• You are viewing the count you wish to modify (See Find and View a Count)
• The count type of the count is Stock – Mesh Count (See Change a Count’s Count Type)

Steps to take

Take the following steps to modify a Stock – Mesh count:

1. If required, tap in the Type of Mesh field and select the type of the reinforcing mesh being counted.
   
   
2. If not already correct, tap in the Number of Sheets in Full Pack field then enter the number of reinforcing mesh sheets in a full pack of mesh.
   
   
3. If required, tap in the Number of Full Packs field then enter the number full packs of reinforcing mesh being counted.
   
   
4. If required, tap in the Number of Loose Sheets then enter the number of loose sheets of reinforcing mesh being counted.
   

The total number of sheets is calculated displayed at the end of the Details section.

Where to from here?

• Create another count in the same section. (See Create a Count from a Count)
• Delete the count. (See Delete a Count)